What to do if my Raven AccuFlow Vortex Farm Equipment console displays flashing “CAL” when the vehicle engine is started?
Check the battery voltage. The console power may be toggled by the vehicle’s ignition switch or connected to a “dirty” power source. Make sure that the power leads from the console cable are connected directly to the battery, and not to chassis ground or another power source.
Covers NH3, agricultural chemicals, hydraulics, electrical, and general safety measures.
Procedure for safely discharging anhydrous ammonia before transport or service.
Step-by-step instructions for assembling cooler, manifold, gauge tree, and valve components.
Procedures for installing HP+ specific components like control node, pump upgrade, and hydraulics.
Procedure for checking the installed system for leaks using compressed air.
Procedure for charging the system and verifying its operation.
Procedure for charging the HP+ system and calibrating pressure transducers.
Instructions for operating the HP+ system in NH3 boost mode.
Procedure to discharge NH3 before service or transport.
General| Flow Meter Type | Vortex flow meter |
|---|---|
| Pressure Range | Up to 150 PSI |
| Accuracy | +/- 1.0% of reading |
| Material | Stainless steel |
| Power Supply | 12 VDC |
| Output Signal | pulse |
To Next Page