CHAPTER 6
66 Viper Pro Installation & Operation Manual
3. Press the button to manually rotate the boom counterclockwise via the UltraGlide system, verifying that the
boom rotates counterclockwise as viewed from behind the machine.
NOTE: If the boom rotates in the wrong direction, the UltraGlide XT valve harness corrections may need to
be changed. Refer to Install the Valve Harness section on page 48 for further information.
NOTE: If there are issues with the AutoBoom system, turn off the machine and correct them immediately. For
additional assistance, refer to the AutoBoom UltraGlide XT Calibration & Operation Manual
(P/N 016-0130-062) or contact your local Raven dealer.
CALIBRATE THE AUTOBOOM ULTRAGLIDE XT SYSTEM
Refer to the AutoBoom UltraGlide XT Calibration & Operation Manual (P/N 016-0130-062) for instructions on
calibrating the system, adjusting system settings, and system operation.
To Next Page
Loading...
