P/N 016-5030-020 Rev. D 97
ENVIZIO PRO AND CRUIZER II CONSOLES CALIBRATION AND OPERATION
RESET DEFAULT
FIGURE 43. SmarTrax MD Settings Screen
Selecting the Reset Defaults resets the SmarTrax MD system settings to the default values.
IMPORTANT: If Reset Defaults is selected, the SmarTrax MD system must be recalibrated before the system can be
enabled. Refer to Calibrate the SmarTrax MD System section on page 77 for information on completing
the SmarTrax MD system calibration.
RECALIBRATING HYDRAULICS
FIGURE 44. SmarTrax MD Settings Screen
Selecting Recal Hydraulics restarts the machine’s steering calibration process. Refer to Calibrate the Machine’s
Steering System section on page 86 for information on completing the machine’s steering calibration.
To Next Page
Loading...