5
P/N 016-5030-020 Rev. D 89
ENVIZIO PRO AND CRUIZER II CONSOLES CALIBRATION AND OPERATION
2. With the engine running at the operating RPM, drive forward at a speed of 5-7 mph [8-11 km/h].
FIGURE 28. SmarTrax MD Enable Icon
3. Enable SmarTrax MD by pressing the steering wheel icon on the display or by tapping the foot/enable switch.
NOTE: When SmarTrax MD is enabled, the steering wheel icon will turn green.
4. Allow SmarTrax MD to run while driving back and forth along the A-B guidance line.
NOTE: If the machine is not operating to the desired specification, it may be necessary to adjust the Line
Acquire Aggressiveness and On-Line Sensitivity values. Refer to the System Adjustments section
below information on adjusting the SmarTrax MD system.
START A JOB
Refer to the Envizio Pro and Envizio Pro II Installation and Operation Manual (P/N 016-0171-148) or Cruizer II
Operation Guide (P/N 016-0171-415) for instructions on starting a job and setting guidance lines.
SYSTEM ADJUSTMENTS
LINE ACQUISITION (LA) MODE AND AGGRESSIVENESS
NOTE: The speed of the LA mode is often limited by the speed of the machine’s hydraulic and steering
system. Increasing the LA value at the maximum vehicle speed may degrade performance of the
SmarTrax MD system.
FIGURE 29. LA Adjustment Panel
To Next Page
Loading...