CHAPTER 3
18 SmarTrax™ MD Calibration & Operation Manual
FIGURE 10. Steering Control Device Selection Screen
3. Select SmarTrax MD from the drop-down box.
4. Select Next.
CALIBRATE THE SMARTRAX MD SYSTEM
IMPORTANT: The switch on the bottom of the mechanical drive must be turned on before calibrating the SmarTrax MD
system.
NOTE: The calibration wizard will be displayed the first time the SmarTrax module is accessed after
installation or any time the Reset SmarTrax option is selected. Refer to Reset Calibration section on
page 37 for additional information about resetting the SmarTrax MD system.
1. Park the machine on a level surface.
2. Locate and select the SmarTrax module. The calibration wizard will start automatically if the SmarTrax MD
system requires calibration.
To Next Page
Loading...