CHAPTER
5
P/N 016-5030-020 Rev. D 71
CHAPTER 5
ENVIZIO PRO AND CRUIZER II
CONSOLES CALIBRATION AND
OPERATION
INTRODUCTION
SOFTWARE COMPATIBILITY
The instructions in this manual apply to Envizio Pro consoles with software version 3.6.0.27 or higher and
Cruizer II consoles with software version 3.1.2.29627 or higher. The SmarTrax node must be running software
version 6.1.90 or higher. If the field computer or node is running with an older version of software, refer to the
Installation & Operation Manual included with the field computer for instructions software versions.
For SmarTrax MD swather operation, the SmarTrax node must be running software version 1.3.60 or higher with
the SmarTrax node software version 6.3.55 or higher. Together, these node software versions support SmarTrax MD
swather control.
SMARTRAX MD STATUS DISPLAY
FIGURE 1. Main Menu
NOTE: The images contained in this chapter are taken from the Envizio Pro display. If a Cruizer II is being
used, the images may vary slightly from the those referenced in this chapter.
Tools
Start Button Exit Button
To Next Page
Loading...