CHAPTER 4
60 SmarTrax™ MD Calibration & Operation Manual
1. Start a job and set a straight A-B guidance line.
NOTE: Refer to the Viper Pro Installation and Operation Manual (P/N 016-0171-122) for information on
starting a job.
2. With the engine running at the operating RPM, drive forward at a speed of 5-7 mph [8-11 km/h].
FIGURE 30. SmarTrax MD Enable Icon
3. Enable SmarTrax MD by pressing the steering wheel icon on the Viper Pro display or by tapping the foot/
enable switch.
NOTE: When SmarTrax MD is enabled, the steering wheel icon will turn green.
4. Allow SmarTrax MD to run while driving back and forth along the A-B guidance line.
NOTE: If the machine is not operating to specifications, manual adjustment of the SmarTrax MD system may
be necessary. Refer to the Advanced Setup Tools section below information on adjusting the SmarTrax
MD system.
ADVANCED SETUP TOOLS
Are these necessary since they also appear in the Advanced Setup and Diagnostics section?
Advanced setup tools allow fine-turning of the system to adjust for operating conditions and improve steering
accuracy. To adjust the steering response on the Viper Pro, touch the SmarTrax area on the Viper Pro main menu.
The following screen will appear:
To Next Page
Loading...