CHAPTER 4
56 SmarTrax™ MD Calibration & Operation Manual
ENGAGE SWITCH CALIBRATION
FIGURE 25. Engage Switch Calibration Screen
1. Review the on-screen instructions.
2. Press and release the foot switch or engage switch.
NOTE: The SmarTrax MD Setup Wizard will automatically advance to the next step in the calibration process
when the engage switch is detected.
WHEEL ANGLE SENSOR (SPS) CALIBRATION
FIGURE 26. SPS Calibration Screen
1. While driving slowly, turn the steering wheel fully to the left wheel lock.
2. Select Left.
To Next Page
Loading...