4
P/N 016-5030-020 Rev. D 55
VIPER PRO CALIBRATION AND OPERATION
8. Select OK.
STEERING SWITCH CALIBRATION
IMPORTANT: The switch on the bottom of the mechanical drive must be turned on before calibrating the steering
system.
FIGURE 24. Steering Switch Calibration Screen
1. Review the on-screen instructions and turn the steering wheel to verify proper operation.
NOTE: The SmarTrax MD Setup Wizard will automatically advance to the next step in the calibration process
when the steering wheel is turned. If it does not, refer to Chapter 6, Troubleshooting for
troubleshooting information. If the problem persists, contact your local Raven dealer for further
information.
2. Proceed to Engage Switch Calibration below to continue with the system calibration.
To Next Page
Loading...