5
P/N 016-5030-020 Rev. D 75
ENVIZIO PRO AND CRUIZER II CONSOLES CALIBRATION AND OPERATION
FIGURE 5. Machine Configuration Menu
3. Select one of the profile options from the bottom of the Machine Type list.
4. Select Next.
5. Select New, Load, or Reset.
• New creates a new machine profile. Once New is selected, the screen will return to the Machine Type list
to allow the operator to select the appropriate tune set and continue with the calibration process. Once
the calibration process is complete, the machine will be associated with the Profile number selected.
• Load allows the operator to select an existing profile. Load will not be displayed as an option until the
machine calibration has been performed and a new profile has been set up.
◦ If the profile chosen has previously been calibrated on the machine, the calibration process is
complete.
◦ If the profile chosen has not been calibrated on the machine, the calibration process must be
completed as outlined in the following sections in this manual.
• Reset clears the previous profile settings. Once Reset is selected, the operator must select the machine
from the Machine Type list and the calibration process must be completed as outlined in the following
sections in this manual. Reset will not be displayed as an option the machine calibration has been
performed and a new profile has been set up.
6. Select Next.
MACHINE-SPECIFIC CONFIGURATION
Before the SmarTrax MD system may be enabled, the field computer and SmarTrax MD system must be calibrated
for the specific vehicle being used. Complete the following steps to configure the machine specifications in the
field computer and the SmarTrax MD system.
To Next Page
Loading...