CHAPTER
4
P/N 016-5030-020 Rev. D 41
CHAPTER 4
VIPER PRO CALIBRATION AND
OPERATION
INTRODUCTION
SOFTWARE COMPATIBILITY
The instructions in this manual apply to Viper Pro software version 3.9.0.8 or higher. The SmarTrax node software
version must be running software version 6.1.90 or higher. If the Viper Pro or node is running with an older version
of software, refer to the Viper Pro Installation & Operation Manual (P/N 016-0171-122) for instructions on updating
the field computer and node software versions.
For SmarTrax MD swather operation, the SmarTrax MD unit must be running software version 1.3.60 or higher with
the SmarTrax node MD software version 6.3.55 or higher. Together, these node software versions support SmarTrax
MD swather control.
SMARTRAX MD STATUS DISPLAY
The current status of the SmarTrax MD system can be determined by the message displayed in the SmarTrax MD
section of the Viper Pro screen
Display Message
The SmarTrax node is detected, but the operator must
accept responsibility for the operation of the SmarTrax
MD system.
SmarTrax MD is detected but not calibrated. The system
must be calibrated before it can be used.
SmarTrax MD is detected, turned on, and calibrated.
SmarTrax MD is detected and in operation in the Online
Sensitivity adjustment mode.
SmarTrax MD is detected and in operation in the Line
Acquisition Aggressiveness adjustment mode.
To Next Page
Loading...