Raven SmarTrax MD - Machine-Specific Configuration

3
P/N 016-5030-020 Rev. D 17
VIPER 4
• New creates a new machine profile. Once New is selected, the screen will return to the Machine Type list
to allow the operator to select the appropriate tune set and continue with the calibration process. Once
the calibration process is complete, the machine will be associated with the Profile number selected.
• Load allows the operator to select an existing profile. Load will not be displayed as an option until a
machine calibration has been performed and a new profile has been set up.
◦ If the profile chosen has previously been calibrated on the machine, the calibration process is
complete.
◦ If the profile chosen has not been calibrated on the machine, the calibration process must be
completed as outlined in the following sections in this manual.
• Reset clears the previous profile settings. Once Reset is selected, the operator must select the machine
from the Machine Type list and the calibration process must be completed as outlined in the following
sections in this manual. Reset will not be displayed as an option until a machine calibration has been
performed and a new profile has been set up.
4. Select Next.
MACHINE-SPECIFIC CONFIGURATION
NOTE: If machine measurements (guidance width, wheel base, etc.) have not already been entered into the
field computer, it will be necessary to enter machine measurements before operating the SmarTrax
MD system. Refer to the Viper/Viper 4+ Installation and Operation Manual (P/N 016-0171-539) for
further information.
Before the SmarTrax MD system may be enabled, the SmarTrax MD system must be calibrated for the specific
vehicle being used. Complete the following steps to configure the machine specifications in the Viper 4 and the
SmarTrax MD system.
FIGURE 9. Vehicle Selection Screen
1. Select the specific machine type from the Machine Type list. If the specific machine is not listed, choose the
generic machine type that best fits the machine:
• SP Sprayer RBoom - Self-propelled sprayer with a rear boom
• FS Tractor - Front-steered tractor
•Articulated
•Track
• Rear Steered - Rear-steered machine
•Swather
2. Select Next.