P/N 016-5030-020 Rev. D 3
IMPORTANT SAFETY INFORMATION
1
Protect harnesses from:
• Foreign objects such as rocks that may fall or be thrown by the unit
• Buildup of dirt, mud, snow, ice, submersion in water and oil
• Tree limbs, brush and debris
• Damage where service personnel or operators might step or use as a grab bar
• Damage when passing through metal structures
IMPORTANT:
• Avoid directly spraying electrical components and connections with high pressure water.
High pressure water sprays can penetrate seals and cause electrical components to corrode
or otherwise become damaged. When performing maintenance:
• Inspect all electrical components and connections for damage or corrosion. Repair or replace
components, connections, or cable as necessary.
• Ensure connections are clean, dry, and not damaged. Repair or replace components,
connections, or cable as necessary.
• Clean components or connections using low pressure water, pressurized air, or an aerosol
electrical component cleaning agent.
• Remove visible surface water from components, connections, or seals using pressurized air
or an aerosol electrical component cleaning agent. allow components to dry completely
before reconnecting cables.
NOTE: This section applies only to European countries where compliance to Roadway Homologation
Regulations are required.
•Roadway operation with this system installed may require additional machine inspection and testing from a
local TÜV authority. Before operating on a roadway, please contact a local TÜV authority for more information.
• The mechanical drive unit must be removed before public roadway travel is attempted. Install the protective
trim around the installed ring gear when the mechanical drive is removed.
• The field computer installation location must not obstruct the machine operator’s view in accordance with
Directive 2008/2/EC.
• Refer to Chapter 8, Roadway Homologation Certification on page 111 for Roadway Homologation certificate
information.
ROADWAY HOMOLOGATION
To Next Page
Loading...