1
Chapter 1: Operation
1.1 Getting started
Displayed information
Your ST60+ Graphic Display uses a high-quality dot-matrix screen to display a
wide range of data, both from Raymarine via SeaTalk, and from other equipment
via NMEA. The exact information available for display depends on what data is
available and on how the display has been set up.
The ST60+ Graphic Display can also supply SeaTalk data to NMEA 0183.
Switching on and off
All the time that power is applied to the instrument, you can use the button to
switch the instrument off and on as follows:
• To switch the instrument off, hold down the button for approximately
5 seconds. After this time, a switch off count down of 4 seconds occurs. Keep
the button pressed during this period, to switch off the instrument.
• To switch the instrument back on, hold down the button for approxi-
mately 1 second.
When the power supply is switched off, none of the instrument buttons has any
effect, until you hold down to switch the power on again.
Notes: (1)
If the instrument power supply is removed (e.g. switched off at the pow-
er breaker) then re-applied, the instrument starts in the ON condition, so
you do not need to use the button to switch it on.
(2)
When the instrument is on, the operation of the button will perform
other operating functions, as described below.
1.2 Accessing information
Information on the ST60+ Graphic Display is organized in groups or ‘chapters’,
and within each chapter, the different types of information are presented as
pages. The ST60+ Graphic Display chapters and pages are shown in the following
Chapter selection and content
illustration. This illustration assumes a system
where all information sources are available and all pages are enabled.
WARNING: Calibration requirement
To ensure this product performs at its best on your boat, you
MUST calibrate it before use, in accordance with the instructions
in
Chapter 4, Calibration
. Do NOT use the product until you have
successfully calibrated it.
81268_3 chap 1.fm Page 1 Tuesday, August 1, 2006 8:28 AM
To Next Page
Loading...
