48 ST60+ Graphic Display Owner’s Handbook
Self test
Self test is intended for engineers engaged in diagnostic procedures. Always set
this to NO .
Note:
If
YES
is selected, you could inadvertently initiate a self test routine. This will not
harm the product but will interrupt operation, so it is therefore NOT recommended.
Leaving Dealer calibration
Hold down the and buttons for 2 seconds to save your settings and exit
Dealer calibration.
4.4 Checking operation
When installation and calibration are complete, check that the ST60+ Graphic
Display performs satisfactorily by carrying out basic checks and NMEA checks,
before operational use.
Basic checks
Ensure that the display shows the appropriate chapters and pages, as described in
Chapter 1, Operation .
When doing this, be aware that some data types may not
be supported by your system and therefore will not be displayed on your ST60+
Graphic Display. If you think that data is missing, ensure that your system
supports this data before assuming that a fault exists.
NMEA checks
Ensure that the display operates satisfactorily with any NMEA equipment to
which it is connected.
Remote group None
Remote sequence None
Parameter Factory default
81268_3.book Page 48 Tuesday, August 1, 2006 8:05 AM
To Next Page
Loading...
