40 ST60+ Graphic Display Owner’s Handbook
Battery alarm threshold
Use the track and reset buttons to set the required voltage alarm threshold, in
the range 9 V to 14 V. Press the
track button to reduce the level and the reset
button to increase it.
The recommended value is 10.5 V.
If you want to switch off the battery alarm, Press the
track button to reduce the
level until OFF is displayed.
Internal alarms on/off
Use the track or reset button to set the internal ALARMS OFF if you do not
want the ST60+ Graphic Display to give alarm indications. Otherwise, set
ALARMS ON .
If you have set the ALARMS ON , set the individual internal alarms as follows:
1. Press the button to display the list of alarms. The first alarm is highlighted,
to indicate you can adjust it.
2. Use the
track or reset button to either enable (✓) or disable (✘) the high-
lighted alarm.
3. Use the button to move the highlight to each alarm in turn, and either
enable or disable it, as described in step 2.
Note:
External alarms (see Auxiliary Alarm select below) will occur, irrespective of the in-
ternal alarm settings.
Variation
If an external magnetic variation value is available from SeaTalk or NMEA, this
will be used by the ST60+ Graphic Display.
If an external variation input is not available, use the button to set
VARIATION ON , then use the
track and reset buttons to set the correct
magnetic variation value.
If you do not want to display the variation value, use the button to set
VARIATION OFF .
Date format
Use the track or reset button to select the required date format. Either United
States (MM/DD/YY) or European (DD/MM/YY).
Time format
Use the track or reset button to select either 12-hour or 24-hour time format.
81268_3.book Page 40 Tuesday, August 1, 2006 8:05 AM
To Next Page
Loading...
