32 ST60+ Graphic Display Owner’s Handbook
.
Defining the NMEA OUT connector function
If a connection is made to the NMEA OUT connector, you must use the
procedures below to define how the
NMEA OUT connector is to be used (i.e. for
either NMEA out data or Auxiliary Alarm), before the ST60+ Graphic Display is
used.:
1. Hold down the and buttons for approximately 2 seconds so that the
User calibration entry screen is displayed.
Note:
The User calibration entry screen will time out to the main display after 7 seconds,
if you do not proceed.
2. Press the button to enter User calibration.
WARNING: Calibration requirement
To ensure this product performs at its best on your boat, you
MUST calibrate it before use, in accordance with the instructions
in
Chapter 4, Calibration
. Do NOT use the product until you have
successfully calibrated it.
or
track
reset
ON OFF
With NMEA ON, the Auxiliary Alarm drive is not available
or
track
reset
ON OFF
or
track
reset
ON OFF
With NMEA OFF, you can switch the Auxiliary Alarm drive ON or OFF
NMEA OUT
on/off
Auxiliary
alarm
select
NMEA OUT
on/off
Auxiliary
alarm
select
D8270-1
81268_3.book Page 32 Tuesday, August 1, 2006 8:05 AM
To Next Page
Loading...
