Raymarine ST60+ - Procedure; User Calibration On;Off

Chapter 4: Calibration 45
Procedure
To carry out Dealer calibration:
1. Hold down the and buttons together for approximately 12 seconds, to
select the Dealer calibration entry page (see
Dealer calibration diagram).
2. Press the
track and reset buttons together, to start Dealer calibration.
3. Referring to the Dealer calibration diagram below, use the button to cycle
to each screen in turn, and set the appropriate values as described below.
User calibration on/off
Press the track or reset button to toggle the User calibration either ON or
OFF as required.
Note: If at any time, you want to access the software version and serial number, you need
to set User calibration
ON .
D6479-1
for approximately 12 seconds
Dealer calibration
To enter Dealer calibration, hold down
and
User cal
on/off
Response Battery voltage
Default resetSelf test entry
Entry
screen
track
reset
track
reset
and
81268_3.book Page 45 Tuesday, August 1, 2006 8:05 AM