Chapter 3: Installation 23
Flush mounting
The Flush Mounting Kit uses a low-profile bezel to reduce the fitted profile of the
instrument, to approximately 0.25 in (6 mm) above the panel fascia.
Fitting the flush mount bezel
In order to flush-mount your ST60+ instrument, you must first replace the
standard bezel with the flush mount bezel as follows:
1. Hold the instrument in both hands with the display towards you.
Surface mounting
412135 52
D8147-1
D8148-1
81268_3.book Page 23 Tuesday, August 1, 2006 8:05 AM
To Next Page
Loading...
