Chapter 3: Installation 31
NMEA to SeaTalk
When supported NMEA data is available at the
NMEA IN connector, it is decoded
and displayed by the ST60+ Graphic Display. The supported NMEA input data is
detailed in the following table.
:
3.4 Starting procedures
Switching on
Switch on the power to your ST60+ instrument. When the power is on, you can
use the button to switch the instrument on and off as described in
Chapter 1,
Operation
.
Use the procedures in
Chapter 1, Operation
to set the backlighting and contrast
to the levels you want.
Data NMEA Header
Bearing & distance to waypoint BWC
Bearing & distance to waypoint rhumb line BWR
Depth below transducer DBT
Latitude and longitude GLL
Time, latitude, longitude, satellites tracked & HDOP GGA
Water temperature MTW
Wind speed & angle MWV
Navigational information RMB
Time, date, lat, long, COG & SOG RMC
Water speed & heading VHW
Distance travelled VLW
COG and SOG VTG
Cross track error XTE
81268_3.book Page 31 Tuesday, August 1, 2006 8:05 AM
To Next Page
Loading...
