Raymarine ST60+ - Contrast

14 ST60+ Graphic Display Owner’s Handbook
2. There are four preset backlighting levels. Momentarily press the button to
cycle through these levels until you reach the level you want.
3. Press any other button to leave the backlighting-adjust mode.
Note: The display will time out to normal operation 5 seconds after the last button press.
Contrast
To adjust the display contrast:
1. Hold down the button for approximately 1 second, to enter backlighting-
adjust mode.
2. While in backlighting-adjust mode, hold down the button for approxi-
mately 1 second, to enter the contrast-adjust mode.
3. Use the
track or reset button to set the contrast to the required level.
4. Press the
page button to leave the contrast-adjust mode.
Note: The display will time out to normal operation 5 seconds after the last button press.
Decrease
contrast
Increase
contrast
LAMPS
reset
track
1 second
1 second
D6435-1
81268_3.book Page 14 Tuesday, August 1, 2006 8:05 AM