46 ST60+ Graphic Display Owner’s Handbook
Response settings
The response values determine the sensitivity of the display to data changes. You
can set each response value from 1 to 15. A low number provides a smooth
response and a high number a much livelier response.
Use the button to select the response you want to set, then use the
track
(decrement) and
reset (increment) buttons to set the required value.
You can set responses for the following data:
•Speed (SPEED RESP.)
•Depth (DEPTH RESP.)
•Heading (HEADING RESP.)
• Wind angle (WIND ANGLE R.)
• Wind speed (WIND SPEED R.)
• Cross track error (XTE RESP.
)
Battery voltage
Use the BATTERY screen to set the voltage reading at the ST60+ Graphic
Display to be the same as the actual supply voltage from the boat’s electrical
system.
To set the voltage reading at the ST60+ Graphic Display:
1. With the BATTERY screen displayed, measure the 12 V supply voltage at
the battery.
2. At the ST60+ Graphic Display, use the
track or reset button to set the dis-
played voltage to the same value as the measured voltage.
Default reset
You can use this screen to reset the operating parameters to the factory default
values. Use the
track and reset buttons to make the required selection.
Note that the selection you make at this screen will be applied when you exit the
screen, so be sure you make the correct selection.
To retain the current values, ensure that the display shows
NO.
WARNING: HIGH VOLTAGE HAZARD
High voltages can cause death or serious injury. Always take
appropriate precautions when working with electricity. Before
accessing the electrical system, ensure you know the location of
high voltage points and stay well clear of them.
81268_3.book Page 46 Tuesday, August 1, 2006 8:05 AM
To Next Page
Loading...
