36 ST60+ Graphic Display Owner’s Handbook
Procedure
To carry out the required setup procedure:
1. Hold down the and buttons for approximately 2 seconds so that the
User calibration entry screen is displayed.
Note:
The User calibration entry screen will time out to the main display after 7 seconds.
2. Press the button to enter User calibration.
3. Referring to the
User calibration
diagram below, use the button to cycle
to the required screen, then set the required values as described below.
Favorite page rollover
Use the track or reset button to set the required Favorite page rollover period,
from 0.5 SEC to 20 SEC. Press the
track button to reduce the rollover period and
the
reset button to increase it.
If you want to be able to select Favorite pages manually as for other chapters, use
the
track button to reduce the value of the rollover until OFF is displayed.
Chapter titles
Use the track and reset buttons to select either:
• ON, so that each chapter title is briefly displayed when the chapter is
selected during normal operation,
or
• OFF, if you do not want chapter titles to be displayed.
Heading type
Use this to define how heading values are displayed. Use the track and reset
buttons to select either magnetic (MAG) or true (TRUE). If a variation value is
not available on SeaTalk, then MAG is selected permanently.
Depth offset
The Depth Offset screen is displayed only if DBT (depth below transducer)
information is received from NMEA. If DBT is not available, the Depth Offset
screen is not displayed.
Depths are measured from the transducer to the sea bed. However, an offset value
can be applied to the depth data, so that the displayed depth reading represents
either the depth from the keel or the depth from the water line.
81268_3.book Page 36 Tuesday, August 1, 2006 8:05 AM
To Next Page
Loading...
