Chapter 3: Installation 33
3. Use the button to go to the NMEA OUT on/off screen.
4. Use the
track or reset button to switch the NMEA OUT function ON or
OFF, as required. If you set:
• NMEA ON, then the Auxiliary Alarm output is disabled and the Auxiliary
Alarm Select screen (the next screen) shows ALARM DRIVE
UNAVAILABLE .
• NMEA OFF, then the Auxiliary Alarm output is available, and you can
switch the Auxiliary Alarm drive ON or OFF at the Auxiliary Alarm
Select screen, using the
track or reset buttons.
5. When you have set NMEA OUT and ALARM DRIVE as required, hold
down the and buttons for approximately 2 seconds to return to nor-
mal operation.
EMC conformance
Always check the installation before going to sea to make sure that it is not
affected by radio transmissions, engine starting etc.
81268_3.book Page 33 Tuesday, August 1, 2006 8:05 AM
To Next Page
Loading...
