Raymarine ST60+ - Chapter 4: Calibration; Introduction; User Calibration

35
Chapter 4: Calibration
4.1 Introduction
Use this chapter to set up and check the ST60+ Graphic Display, before it is used
operationally. Instructions are given to enable you to:
• Define the function of the
NMEA OUT connector (see Chapter 1, System
Connections
).
• Carry out Dealer calibration.
• Check basic operation.
4.2 User calibration
A User calibration facility enables you to:
• Set the Favorite page rollover period, or switch the rollover off.
• Switch chapter titles on or off.
• Set whether headings are displayed in true or magnetic form.
• Check and set the depth offset value. Only available if suitable information is
available from NMEA.
• Set the voltage at which a battery alarm will occur.
• Enable/disable individual local alarms.
• Set the date format.
• Set the time format.
• Set the instrument time to local time.
• Select the units in which NMEA data are displayed.
• Select the function of the display
NMEA OUT connector. This is either
• A remote alarm output for the Auxiliary Alarm (NMEA OFF).
or
• NMEA output signals.
• Enable/disable individual remote alarms.
• Enable/disable the pilot pop up display.
• Configure the instrument to display specific pages.
81268_3.book Page 35 Tuesday, August 1, 2006 8:05 AM