Raymarine ST60+ - Leaving User Calibration; Dealer Calibration; Summary

44 ST60+ Graphic Display Owner’s Handbook
Leaving User calibration
Hold down the and buttons for 2 seconds, to save your settings, exit User
calibration and resume normal operation.
4.3 Dealer calibration
Summary
The Dealer calibration procedures enable you to set:
• Access to User calibration on/off.
• Response settings for speed, depth heading wind angle, wind speed, VMG,
course over ground and speed over ground.
• The correct battery voltage reading.
Dealer calibration also gives access to:
• A default reset screen. This enables you to re-apply the factory settings if you
want to reset the instrument to a known operating condition.
• A self-test entry screen.
BATTERY
Battery voltage Environment
TIME & DATE
Time and date Environment
S. TEMP GRAPH
Sea temperature graph Environment
VOLTS GRAPH
Battery voltage graph Environment
PILOT STATUS
Pilot status Pilot
RUDDER ANGLE
Rudder Angle Pilot
FAVORITE 1
Favorite page 1 Favorite
FAVORITE 2
Favorite page 2 Favorite
FAVORITE 3
Favorite page 3 Favorite
FAVORITE 4
Favorite page 4 Favorite
FAVORITE 5
Favorite page 5 Favorite
FAVORITE 6
Favorite page 6 Favorite
FAVORITE 7
Favorite page 7 Favorite
Title Page affected Chapter
81268_3.book Page 44 Tuesday, August 1, 2006 8:05 AM