Pull Header
Ensure before fastening header box to the door frame that your holes for high and low voltage wires match. Header box
should be referenced to the hinge side of the door and 1 3/8” above the bottom of the door frame (see figure below).
For most applications, the header is equal to the door opening plus 3”.
This allows for a 1.5 inch space on either side of the header box to anchor the header box properly to the frame.
For correct sized header, the header box should be anchored with a minimum of (6) six #14 x 1” Pan Quad Type A screws
(provided), but will also depends on what is being screwed into.
• The locations of the screws on the header will be application dependent.
• Fasten the header body as application requires. The header must support 200lbs.
• Do Not use Drywall Screws or Hollow Wall Anchors to mount the back plate / header.
• Header on pull applications must be mounted so the main drive pinion safety washer and machine screw
are above the top of the door. This is to ensure the spindle does not obstruct the swing path of the door.
• For Push application with standard arm, the reveal is up to 4”. For greater reveal, extended arm is
needed.
• For application with Universal Arm, Header will be installed differently. See section 3.3.
4 1/2 in
[ 114mm ]
FILLER PLATE AS
REQUIRED BY OTHERS
REINFORCEMENT
BY OTHERS
2 1/4 in
[ 57mm ]
2.0 OPERATOR INSTALLATION
Pg. 17
HA8-SP Manual V. 7.0
Record Canada Inc.
Toll Free: 1-877-348-6837
info.ditec.ca@recorddoors.com
www.recorddoors.ca
Record USA Inc.
Toll Free: 1-866-901-4284
info.ditec.us@recorddoors.com
www.recorddoors.com
To Next Page
Loading...
