Record HA8-SP - Operator Tuning; How It Works

4.2 How it Works
Below illustrations explain how the Limit Switches (Magnet) are related to door position.
STEP 1 - Door Starts in Close position
UPPER MAGNET IS PAST
LATCH CHECK REED
(NO GREY WIRE) DURING
TOP VIEW
LOOKING AT THE TOP
OF OPERATOR - MAGNET SIDE
REEDS
CLOSED POSITION
REED SWITCH
HARNESS
(GREY WIRE)
REED SWITCH
LOWER MAGNET
UPPER MAGNET
(LIMIT SWITCH)
(LIMIT SWITCH)
SPINDLE ROTATION
FOR DOOR OPEN
BOTTOM VIEW
LOOKING AT THE BOTTOM
OF OPERATOR - STOPPER SIDE
STEP 2 - Door Opens to Back Check
STOPPER NUT
& SCREW
OPERATOR ARM
SPLINE STOP
(STOPPER)
SPINDLE ROTATION
FOR DOOR OPEN
DOOR 90% OF FULLY OPEN POSITION
(80-81 FOR A 90 OPEN DOOR) AND
SHOULD START TO SLOW DOWN NOW
TOP VIEW
LOWER MAGNET IN LINE WITH
BACK CHECK REED (WITH
GREY WIRE) DURING START
OF BACK CHECK POSITION
LOWER MAGNET
(LIMIT SWITCH)
UPPER MAGNET
(LIMIT SWITCH)
SPINDLE ROTATION
FOR DOOR OPEN
4.0 OPERATOR TUNING
YOU ARE ON THIS SIDE OF
DOORWAY
YOU ARE ON THIS SIDE OF
DOORWAY
Pg. 34
HA8-SP Manual V. 7.0
Record Canada Inc.
Toll Free: 1-877-348-6837
info.ditec.ca@recorddoors.com
www.recorddoors.ca
Record USA Inc.
Toll Free: 1-866-901-4284
info.ditec.us@recorddoors.com
www.recorddoors.com