Record HA8-SP - Table of Contents

8.0 ADA ADJUSTMENTS
63
9.0 INSTALLATION WRAP UP
64
10.0 MANUFACTURER INFORMATION 69
Table of Contents
1.1 Replacement Parts
1.2 General Information
1.3 Technical Specifications
1.4 Door Handings
1.5 Consideration of Surroundings
1.6 Electrical
2.1 Pre-Mounting Header Box Instructions
2.2 Operator Layout and Handing - Push and Pull
2.3 Double Egress Header
2.4 Gearbox Installation
2.5 Control Board Installation
2.6 Connect Motor Wire Leads
3.1 Push Arm
3.2 Pull (Z-arm)
3.3 Universal Arm - Pull and Push
3.4 Center Spindle (Concealed)
3.5 Center Hung
4.1 Operator Tuning
4.2 How it Works
4.3 Back Check and Latch Adjustment
4.4 Spring Tension Adjustment
5.1 Basic Operation
5.2 Operation Switch
6.1 Digital Board Specification (Single Board)
6.2 Connection Diagram - Low Energy (ANSI A156.19)
6.3 Connection Diagram - Fully Automatic (ANSI 156.10)
6.4 Programing Specification
6.5 Programming - Trouble Shooting
6.6 Safety Monitoring
6.7 Safety Sensor Connection - BEA Bodyguard
6.8 Safety Sensor Connection - BEA Superscan
6.9 Safety Sensor Connection - Optex OA-FLEX
7.0 DUAL DOOR PROGRAMMING 57
`
7.1 Dual Door Digital Board Specification (FA8 only)
7.2 Wiring Diagram
7.3 Programming Specification
7.4 Programming - Trouble Shooting
9.1 Additional Components:
Sensor(s) / Knowing Act Devices
9.2 Header Cover
9.3 Safety Decals
6.0 DIGITAL BOARD & PROGRAMMING 45
1.0 BEFORE INSTALLATION
7
5.0 DOOR OPERATING MODE
44
4.0 OPERATOR TUNING
35
3.0 ARM INSTALLATION
22
2.0 OPERATOR INSTALLATION
13
Pg. 4
HA8-SP Manual V. 7.0
Record Canada Inc.
Toll Free: 1-877-348-6837
info.ditec.ca@recorddoors.com
www.recorddoors.ca
Record USA Inc.
Toll Free: 1-866-901-4284
info.ditec.us@recorddoors.com
www.recorddoors.com