28
Always perform a functions check before the first flight
or mission of the day. It can be performed immediately
before a mission or in advance, dependent upon time
constraints and mission needs.
FUNCTION CHECK PROCEDURES:
1. Acquire GPS signal
2. While on the ground, safely test the arm and
disarm functions:
a. Press the ARM button
b. Press the DISARM button
3. Arm the system
4. Takeoff
5. Climb approx. 5-10 ft (1-3 m), out of ground effect
6. Hold for approximately 10 seconds, checking for
any uncommanded change in heading
7. Yaw right 360° and return to starting point
8. Yaw left 360° and return to starting point
9. Pitch forward and return to starting point
10. Pitch backward and return to starting point
11. Roll right and return to starting point
12. Roll left and return to starting point
13. Either continue on to performing a mission, or land
and disarm to start the mission at a later time
Assigned (if not using default
settings), calibrated, verified
Set to user’s site, mission,
and environment
Stream
Stream
Between -20 dBm and
-50 dBm
Accessory Lights
(optional)
Uploaded, displays in TAC
E-Stop
* Denotes Impact of Safety of Flight
To Next Page
Loading...