37
automatically disarms when on the ground for 3-4
seconds.
To land at the current position at any time, touch the
LAND button in the FLY TOOLS box. Confirm landing by
moving the confirmation slider to the right.
Alternatively, hold the left joystick that controls
throttle in a continuous down position until the drone
automatically disarms when on the ground for 3-4
seconds.
RETURN TO LAUNCH (RTL)
The return to launch (RTL) function is used under
normal circumstances and initiates the pre-
programmed landing sequence to a pre-determined
takeoff / landing location.
The RTL settings can also be customized in the SAFETY
SETTINGS screen for abnormal flight situations. These
pre-determined fail-safes will automatically trigger a
RTL.
The drone automatically disarms when on the ground
for 3-4 seconds.
To initiate the RTL sequence via the TAC soft
key. Touch the Return button in the FLY
TOOLS box and move the confirmation slider
to the right.
Alternatively, press the front left momentary switch
button.
EMERGENCY STOP (E-STOP) / DISARM
The Emergency Stop (E-Stop) function is designed to
immediately cut off power to the motors and cease all
momentum of the drone. This causes the drone to fall
exactly where the motors lose power, resulting in no
control over where the drone lands.
This function is intended to be used in emergency
situations only, and not for regular landing/disarming
situations. The airframe will be unable to recover itself
back into flight once the E-Stop has been activated and
damage to the drone can be significant.
To disarm the drone via the E-stop button, flip open
the right top-panel guard door, and press the red
button.
The E-Stop will shut off propulsion and the
vehicle will immediately fall from the sky.
This may result in:
• Partial or
complete loss of the
airframe, camera, gimbal, arms,
motors, payloads and/or props upon
impact.
• Partial or complete loss of data.
•
Damage to property on the ground
upon impact.
• Significant injury or death of person(s)
upon impact.
To Next Page
Loading...