Renkforce RF500 Maker Construction Kit - Page 123

123
(1) Loopsarecircles,thataredrawnaroundtheobjectwhenprintingstarts,stabilisethelamentowbeforetheactualobjectisprinted.Here,
number,distancefromtheobject,heightandminimumlengtharespecied.
(2) "Brim" is a thin edge that is placed right around the object to increase the footprint and thus adhesion to the printing plate. Here, the width
ofthebrimisspecied.
(1) Selectionandadjustmentofthesupportingmaterialthatisneededwhenprintingcomplexobjectssuchasbridgesorhollowspaces(poss.
requiredforprintingobjectwithoverhangs>45°).
Therstprintingattemptsshouldbewithoutasupportingbrimsincetheresulthereisusuallybetteragain.
1
2
1