Renkforce RF500 Maker Construction Kit - 9 Required Tools and Material

14
9.RequiredToolsandMaterial
Thesecondpart("Maker-constructionkit/constructionkit")ofthischapter("9.RequiredToolsandMaterial")andthe3subsequent
chapters("10.AssemblyoftheMechanicalParts","11.MountingoftheElectricalComponents"and"12.FinalWork")generallyare
only relevant for purchasers of the maker construction kit / construction kit. Owners of the preassembled device can skip those
chapters.
However, the chapters are helpful when there is an error or smaller repairs are necessary.
Preassembled device
• Hexkey4mm
Maker-constructionkit/constructionkit
• Differentscrewdrivers(cross-headandslotted)
• Hexkey1.5mm/2mm/2.5mm/3mm/4mm
• Externalhexkeysocketwrenches4mm/5mm/5.5mm/6mm/7mm
• Externalhexkeyopen-endedwrenches5mm/6mm/7mm/8mm/10mm/11mm/13mm
A hexagon socket wrench or a hexagon spanner may be used in some cases.
• Hammer
• Stopangle
• Calliper
• Wirecutter
• Smallatpliersandsmalllong-nosepliers
• Threadlockervarnish,mediumstrength
• Feelergauge0.3mm
• Multimeterforvoltagemeasuring(300mV/500mV);measurementrange<1V