Renkforce RF500 Maker Construction Kit - G) Print

119
g) Printing
Theprintingleproducedinthismannercanbeprintednow.Therearetwooptionsforthis:
• SavetheprintingleonanSDcardtoprintoutstand-alone.Forthis,click"Savetole"(1).Thissavestheleas*.gcodeandmustbeset
atthesametimewhenyousavethelefromtheG-codeeditor(discicon).TheprecisecontentoftheG-codewillbesavedintothelehere.
• Thesecondpossibilityistosendtheledirectlytotheconnected3DprinterviatheUSBinterfaceofthecomputerandprintit.
• Click"Print Preview" and then the button "Print"(3),tostarttheprintout.
• Whileprinting,thelogwindow(4)belowtheimageshowscurrentinformationonsoftware,slicerandprinter.
• Youcanalsotrackprogressofyourprintinthemainwindow(5).
4
5
1 2
3