Renkforce RF500 Maker Construction Kit - B) Menu Overview

91
b) Menu Overview
Operation takes place via the operating switch at the printer:
• Turningtheactuatingbuttonservesnavigationinthemenustructure(up/down)oradjustmentofvalues.
• Pushingtheoperatingbuttonservesconrmationofaselectioninthemenuandcallingofthemenustructurefromthemainmenu.
Themenustructuremaydeviateslightlydependingonrmware.
Info screen
Prepare Main
Auto home
Set home offsets
Move axis Prepare
Move 10 mm Move axis
MoveX MoveX: +000.0
MoveY MoveY: +000.0
Move 1mm Move axis
MoveX MoveX: +000.0
MoveY MoveY: +000.0
Move Z Move Z: +000.0
Extruder Extruder: +000.0
Move 0.1mm Move axis
MoveX MoveX: +000.0
MoveY MoveY: +000.0
Move Z Move Z: +000.0
Extruder Extruder: +000.0
Disable steppers
Preheat PLA Prepare
Preheat PLA
Preheat PLA Bed
Preheat ABS Prepare
Preheat ABS
Preheat ABS Bed
Cooldown
Tune Main
Speed: 100 Speed: 100
Nozzle: 230 Nozzle: 230
Fan speed: 255 Fan speed: 255
Flow: 100 Flow: 100
Control Main
Temperature Control
Nozzle: 0 Nozzle: 0
Bed: 0 Bed: 0
Fan speed: 0 Fan speed: 0
Autotemp: Off/On