Renkforce RF500 Maker Construction Kit - Page 94

94
PID-D: +114.00 Controller values for hot end
PID-C: 100 Controller values for hot end
Preheat PLA conf Fan speed: 0 Setting the fan speed for the function "Preheat PLA"
Nozzle: 180 Setting the extruder temperature for the function "Preheat PLA"
Bed: 70 Setting the printig plate temperature for the function “Preheat PLA”
Store memory Saves the setting for the function "Preheat PLA"
Control
Temperature Preheat ABS conf Fan speed: 0 Setting the fan speed for the function "Preheat ABS"
Nozzle: 240 Setting the extruder temperature for the function "Preheat ABS"
Bed: 110 Setting the printig plate temperature for the function “Preheat ABS”
Store memory Saves the setting for the function "Preheat ABS"
Motion Accel: 1000 Controller values for movement
VXY-jerk:5 Controller values for movement
Vz-jerk: +000.40 Controller values for movement
Ve-jerk: 5 Controller values for movement
VmaxX:300 Controller values for movement
VmaxY:300 Controller values for movement
Vmax Z: 5 Controller values for movement
Vmax E: 100 Controller values for movement
Vmin: 0 Controller values for movement
VTrav min: 0 Controller values for movement
AmaxX:3000 Controller values for movement
AmaxY:3000 Controller values for movement
Amax Z: 0 Controller values for movement
Amax E: 9000 Controller values for movement
A-retract: 9000 Controller values for movement
A-travel: 1000 Controller values for movement
Xsteps/mm:+080.00 Controller values for movement
Ysteps/mm:+080.00 Controller values for movement
Zsteps/mm: +1060.0 Controller values for movement
Esteps/mm: +0127.0 Controller values for movement
Filament E in mm3: Off/On Controller values for movement
Fil. Dia.: 1,750 Adjustingthelamentdiameter
Store memory Saves all changed settings in the EEPROM
Load memory Loading saved settings from the EEPROM
Restore failsafe Resets all settings to defaults
NoSDCard/PrintfromSD No SD Card: No SD card is inserted.
PrintformSD:SelecttheprintlefromtheSDcard.
Formoreinformation,seethewebsiteofthermwaremanufacturer:
http://reprap.org/wiki/Marlin
http://marlinfw.org/