Renkforce RF500 Maker Construction Kit - Page 98

98
Turntheoperatingknob(10)untilthemenuitem"Bed:0" is selected
andpushthebuttonoftheoperatingknob(10).
Turntheoperatingknob(10)totherightuntilthedesiredvalue"60"
(here:60°C)isdisplayed.Theheatingelementisheatedupatonce
after turning.
Toreturntothemenu,pushtheoperatingknob(10).
Now the same value as set before should be shown here.
Inourexample,wehavechosentheoptimaltemperatureforthela-
mentused(here:PLA).Youcanadjustthevalueaccordingtoyour
lament.
The printer will switch back to the main menu automatically after a
few seconds. The previously set target temperature and the current
temperature of the extruder below are displayed here.
Wait until the extruder and the heating element for the printing plate
are completely heated up. Let both continue to heat for at least 10
minutes until the full expansion is reached. Then continue.