Repak RE20 - Page 113

113
3.
Place the roll of film on its shaft.
See Figure 5.5.
Get help with lifting the roll of film.
4.
Replace the film guide on the film roll.
-
5.
Line up the film roll.
Use the setting button (see Figure
5.5) and fix it with the lock nut.
Make sure that the setting button
does not turn while being locked.
6.
Weigh the film guide down, if needs be,
using extra weights.
Use help when lifting heavy
weights.
7.
Place the film along the film rollers.
For the sequence, see Figure 5.5.
Roll out sufficient film.
8.
Place the film in the chain clips.
Draw the film tight when
positioning it (see illustration 5.5,
bottom film).
9.
Feed the film into the machine a few
strokes.
Check that the film is not running
crooked in the machine. Use the
button next to the film infeed roller
to feed the film in slowly (see
Figure 5.5).
10.
Choose the required operational mode
and activate the machine.
See paragraph 5.2
Remark:
Never allow the bottom film to be fed into an activated seal station without any top
film. If you do, the bottom film will stick fast to the seal plate.