78
4.4.2 Operations
This menu is accessed by pressing the ‘PROGRAM’ button in the main menu
(see Figure 4.21)
Here various programs can be chosen.
The programs can only be chosen when they are valid for the type of machine.
4.4.2.1 Forming programs
No Forming:
= no forming of bottom web.
Top Heater:
= heating from above in the same stroke as forming.
Pre Heater:
= heating 1 stroke before forming.
Plug after forming:
= forming first and after a delay the plug.
Forming after plug:
= plug first and after a delay the forming.
4.4.2.2 Sealing programs
Vacuum with time:
= evacuation only with time.
Vacuum with sensor and time:
= evacuation with pressure and time.
Vacuum and gas with time:
= evacuation and gas only with time.
Vacuum and gas with sensor and time:
= evacuation and gas with pressure and time.
4.4.2.3 Cross cuttings
Punch:
= rigid film puncher.
Guillotine:
= flexible film cutter type guillotine.
Servo driven punch:
= Servo driven punch for ridged and flexible film, applied for more
than 2 positions.
Pneumatic driven punch:
= Pneumatic driven punch only for 2 positions.
Figure 4.21 Operations sequence
To Next Page
Loading...