35
before the support bars can be removed. (To see how to shift the servo manually to another
position see paragraph 4.4.12)
The packages also require support following the loading area. This is achieved with shorter
product support bars (see figure 3.9, pos. 3.)
The crosscutting is situated on the outfeed extension. Support is needed especially before
and after the cross cutting device (see figure 3.9 pos. 2.)
At the longitudinal cutter (no. 1) the product support bars have extra functions: providing
protection from the blades and positioning the packages in accordance with the knives.
To Next Page
Loading...