How Does the SmartMonitor 2 Work?
14
Industry Canada CS-03 Notice
NOTICE: The Industry Canada (IC) label on the SmartMonitor 2 identifies certified equipment. This
certification means that the equipment meets certain telecommunications network protective, operational,
and safety requirements as prescribed in the appropriate Terminal Equipment Technical requirements
document (s). The Department does not guarantee the equipment will operate to the user’s satisfaction.
Before installing the SmartMonitor 2, users should ensure that it is permissible to be connected to the
facilities of the local Telecommunications Company. The equipment must also be installed using an
acceptable method of connection. The customer should be aware that compliance with the above
conditions might not prevent degradation of service in some situations.
The Respironics Service Center should coordinate repairs to certified equipment at 1-800-345-6443. Any
repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect the equipment.
Users should ensure, for their own protection, that the electrical ground connections of the power utility,
telephone lines, and internal metallic water pipe system, if present, are connected together. This
precaution may be particularly important in rural areas.
Caution
: Users should not attempt to make such connections themselves, but should contact the
appropriate electric inspection authority, or electrician, as appropriate.
The Ringer Equivalent Number (REN) assigned to the SmartMonitor 2 provides an indication of the
maximum number of terminals allowed to be connected to a telephone interface. The termination of an
interface may consist of any combination of devices subject only to the requirement that the sum of
Ringer Equivalent Numbers of all the devices does not exceed five (5.0).
FCC Part 15
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
To Next Page
Loading...
