Respironics SmartMonitor2 - Troubleshooting

Transferring SmartMonitor 2 Information
57
Transferring SmartMonitor 2 Data Using a Computer
Direct Connection can download the SmartMonitor 2 data to a computer. The Synergy-E software is
required to download the SmartMonitor 2.
The SmartMonitor 2 can be placed in Communication Mode or Monitoring Mode. If Monitoring Mode is
chosen, all alarms and record parameters are functional.
Communications Mode Setup
The download cable must be connected to the SmartMonitor 2 and the computer before turning
the SmartMonitor 2 on.
 Connect the download cable to the I/O connections port on the monitor and the COM Port on the
computer.
 The monitor can be placed in Communications Mode.
 Press and release the POWER button to turn the SmartMontior 2 on.
 Press and hold the blue RESET button.
 Wait until the monitor alarms constantly.
 Release the RESET button. Briefly press and release the RESET button again. The SmartMonitor
2 display will read “Monitor is in Communication Mode”.
 The SmartMonitor 2 beeps every 10 seconds when it is in the Communications Mode but is not
electronically connected or linked to anything. This is a reminder that the SmartMonitor 2 is
powered on for working with the computer, memory card, or modem, but not for monitoring the
infant.
Refer to the Synergy-E software for instruction on Direct Connection Downloading of the
SmartMonitor 2.