Respironics SmartMonitor2 - View Menu Mode

Setting Alarm and Recording Limits
28
Menu Option LCD Display Description of Option or Instructions
Modem Speed - Host Modem Speed – Host The default setting is 115,500Bps. This
setting should not be change unless
directed to do so by Respironics
Technical Support.
Software Revision SOFTWARE REVISION Display-only menu. Displays the revision
of the Embedded Application Code.
Mmode SW Revision MMODE SW REVISION Display-only menu. Displays the revision
of the Maintenance Mode Code.
Bblk SW Revision BBLK SW REVISION Display-only menu. Displays the revision
of the Boot Block Code.
Serial Number SERIAL NUMBER Display-only menu. Displays the Serial
Number.
View Menu Mode
Should there be a need, the SmartMonitor 2 also allows you to use a View Only option of the Menu
Selections.
The caregiver can download monitor data to a PCMCIA card using the View Menu but cannot
make any changes to the settings in the monitor.
 Press the POWER button ON. After a short delay, the display will read:
INITIALIZING PLEASE WAIT
Then,
MENU MODE? ENTER PROPER KEY SEQUENCE
 Press the keys in the following sequence within 10 seconds:
 Press the ENTER button once.
 Use the tu Up and Down arrow button to scroll through the menus.