Transferring SmartMonitor 2 Information
55
SmartMonitor 2 will beep 5 times. After the transfer, you may disconnect the phone line from the
monitor and the phone will work normally. Turn the monitor off in the normal way.
Press and hold the blue RESET button.
Press and release the gray POWER button.
Wait 2 seconds, and then release the RESET button.
You can now resume monitoring the baby.
Be aware that some features available on your phone may interfere with the download: Call
Waiting, Call Forwarding, and Party Lines all increase the likelihood of problems when
downloading. Call Waiting cannot be disabled when receiving a phone call.
Modem Auto Answer in Monitor Mode
The SmartMonitor 2 must be connected to AC power during modem download.
1. Connect a phone cord from the wall jack to the modem connector on the back of the SmartMonitor 2.
If there is an emergency and access to the telephone is required while the modem is in use,
remove phone cord from modem slot and use a working phone.
2. To allow the SmartMonitor 2 to work with the modem when the monitor is in monitor mode (the baby
is being monitored):
When the Home Care Dealer calls for a download and the phone rings, the caregiver should
press and hold down the blue RESET button.
Hold down the RESET button until the phone stops ringing indicating that the monitor has
answered the call.
3. The dealer will now use the Synergy-E software to transfer the SmartMonitor 2 information.
4. The amount of time to transfer the information will vary. When the transfer is complete the
SmartMonitor 2 will beep 5 times. After the transfer, disconnect the phone line from the monitor and
the phone will work normally.
Be aware that some features available on your phone may interfere with the download: Call
Waiting, Call Forwarding, and Party Lines all increase the likelihood of problems when
downloading. Call Waiting cannot be disabled when receiving a phone call.
To Next Page
Loading...
