Synchronous Motors MKD Important Instructions on Use 2-1
DOK-MOTOR*-MKD*******-PR07-EN-P Version7.0 19.05.2004
2 Important Instructions on Use
2.1 Intended Use
Introduction
In their design and manufacture, the products by Rexroth reflect the
latest state of technology. Before they are delivered, they are checked
for their operationally safe state.
The products may only be used as intended. If they are not used as
intended, situations may arise resulting in injuries to property and
persons.
Note: For damage caused by products not being used as intended,
Rexroth, as manufacturers, do not give any warranty, assume
any liability, or pay any damages. Any risks resulting from the
products not being used as intended are the sole
responsibility of the user.
Before using the products by Rexroth, the following requirements must
be fulfilled so as to ensure that they are used as intended:
• Anybody handling one of our products in any manner must read and
understand the appropriate safety instructions and the intended use.
• If they are hardware components, the products concerned must be
left in their original state, i.e. it is not permitted to modify them
structurally. Software products may not be decompiled; their source
codes may not be altered.
• Damaged or defective products may not be installed or put into
operation.
• It must be ensured that the products are installed, operated and
serviced according to the regulations and environmental conditions
specified in the documentation.
To Next Page
Loading...
Need help?
General
