Synchronous Motors MKD Contents III
DOK-MOTOR*-MKD*******-PR07-EN-P
Connection diagram ..........................................................................................................12-2
12.3 Motors with connector receptacle ............................................................................................12-4
Connection diagram ..........................................................................................................12-4
12.4 Blower connector ....................................................................................................................12-6
Type (1) ............................................................................................................................12-6
Connecting and mounting the blower .................................................................................12-7
12.5 Connection Cable....................................................................................................................12-8
Dimensioning of power cable.............................................................................................12-8
Selection of connection cable ............................................................................................12-9
13 Application Instructions 13-1
13.1 Operating Conditions...............................................................................................................13-1
Setup Height and Ambient Temperature ............................................................................13-1
Vibration and Shock Loads................................................................................................13-2
13.2 Degree of protection................................................................................................................13-3
Option sealing air “sealing air: principle” connection...........................................................13-4
Selecting the Degree of Protection.....................................................................................13-5
13.3 Design and Installation Positions.............................................................................................13-6
Prime Coat and Housing Varnish.......................................................................................13-6
13.4 Blower.....................................................................................................................................13-7
13.5 Holding Brakes........................................................................................................................13-8
13.6 Output Shaft and Motor Bearing ..............................................................................................13-9
Plain shaft .........................................................................................................................13-9
Output shaft with key.........................................................................................................13-9
Output Shaft with Shaft Sealing Ring...............................................................................13-10
Bearings and Shaft Load .................................................................................................13-11
13.7 Motor Encoder.......................................................................................................................13-13
13.8 Acceptances, Approvals ........................................................................................................13-14
CE mark..........................................................................................................................13-14
UR, cUR Listing...............................................................................................................13-14
14 Handling 14-1
14.1 Identifying the Goods ..............................................................................................................14-1
14.2 Type Labels ............................................................................................................................14-1
14.3 Instructions on the Packing......................................................................................................14-2
14.4 Storage ...................................................................................................................................14-3
14.5 Transport and Handling...........................................................................................................14-3
15 Assembly 15-1
15.1 Skilled Technical Personnel.....................................................................................................15-1
15.2 Mounting the Motor .................................................................................................................15-1
15.3 Connecting the Motor ..............................................................................................................15-3
Motor with connection box .................................................................................................15-4
Motors with plug-in connectors ..........................................................................................15-6
16 Startup, Operation, and Maintenance 16-1
To Next Page
Loading...
Need help?
General
