© Xiamen RGBlink Science & Technology Co., Ltd.
Ph: +86 592 5771197
| support@rgblink.com | www.rgblink.com
PTZ Control interface.
The following operations are explained with examples of using mini-edge to control ONE camera
and simultaneously control FOUR cameras.
Example 1: mini-edge controls ONE camera.
1) Connect mini-edge and the camera directly via an Ethernet cable；
2) User Number Button on the control panel to enter IP address of the camera in the following
interface and then rotate ENTER knob to choose "Enter" to save. (Note: The IP address of
mini-edge and camera controlled should be in the same LAN.）
Example 2: Use mini-edge and switch to control FOUR cameras.
1) Use the ping command to analyze network connectivity, check if IP address of mini-edge and
the cameras are occupied, operations please refer to FAQ.
2) Enter PTZ configuration interface below to set the camera's IP address, then choose "Enter" to
save. (Make sure IP address has not been occupies, and IP address of mini-edge and camera are in
the same LAN.)
To Next Page
Loading...
Need help?
General