26
GA--A 202
5.3.1 Speed adjustment
Typical current speeds for rotary blades:
100 - 1500 rpm
Recommended speed for rotary abraders:
800 - 3000 rpm
(in special cases up to 6000 rpm ; only POWER STICK M4)
Efficient speed for oscillation mode:
100 - 1500 rpm
.
NOTE!
Cutters only cut when turning clockwise.
High speeds increase friction, which may result in abrasion, wear and the
formation of cracks in the abraders.
CAUTION!
Caution at high speeds beyond 3000 rpm (only POWER STICK M4
)
Danger of thermal damage to the tissue due to excessive heat.
Ensure sufficient cooling of the tissue and the tool by adequate irrigation.
Useathighspeedsshouldbelimitedtotheshortestpossibletimeand
under moderate application pressure.
To Next Page
