• p.72 "Setting Up a Client Computer"
Setting Up a Client Computer
Follow the procedure below to configure a computer as a client computer and connect it to the shared
printer. Make this setting when installing the printer driver from the CD-ROM provided.
• For Windows 2000/XP/Vista, Windows Server 2003, and Windows NT 4.0, log on as an
administrator (a user with an administrator right).
Configure a computer connected to the network where the print server is connected.
1. Start Windows, and then insert the “Driver, Manual & Utility” CD-ROM into the CD-ROM
drive.
Quit all other applications currently running.
When
starting Windows, a wizard for adding new hardware may open. If this happens, click [Cancel].
Check again that the power is off.
2. Select a language for the interface, and then click [OK].
3. Click [Printer Driver].
4. Read the entire license agreement carefully. If you accept its terms, click [I accept the
agreement], and then click [Next >].
5. Click [Connected via LAN].
6. Click [Next >].
7. Click the plus mark next to a printer name.
8. Click [Port:< LPT1: >] under [Printer name:].
9. Click [Add].
10. Click [Network Printer].
11. Click [OK].
12. Select a shared printer.
13. Click [OK].
14. Check that [<\\servername\sharedprintername>] appears after [Port:].
15. Click [Continue].
Installation starts.
16. Select whether or not to open the Status monitor automatically.
17. Click [Next >].
18. Check the installation result, and then click [Finish].
2. Preparing for Printing
72
To Next Page
Loading...
