When DHCP is set to on, the subnet mask cannot be changed. To change it, set DHCP to off.
Contact your network administrator for information about the network configuration.
Default: 0.0.0.0
Gateway Address
You can specify the gateway address.
When DHCP is set to on, the gateway address cannot be changed. To change it, set DHCP to
off. Contact your network administrator for information about the network configuration.
Default: 0.0.0.0
Active Protocol
You can select the active protocol.
• TCP/IP
Default: Active
Ethernet Speed
You can select the network speed to operate the printer.
• Auto Select
• 10Mbps Half D.
• 10Mbps Full D.
• 100Mbps Half D.
• 100Mbps Full D.
Default: Auto Select
USB Setting
You can specify the settings related to communication when the computer and printer are connected
via USB. Usually, you do not need to change these settings.
After changing this setting, turn the machine off and then back on.
USB Speed
• Full Speed
• Auto
Default: Auto
Port Setting
• On
• Off
Default: Off
Specifying the Interface and Network Settings using the Printer's Control Panel (Host Interface Menu)
75
To Next Page
Loading...
